Plan chemical storage around current safety data, incompatibilities and credible spill paths. A category label or storage chart alone cannot prove a warehouse layout is safe.
Chemical segregation starts with the products actually stored and how a leak, spill or fire could bring them together. Use current safety data sheets (SDSs), container information and a site-specific compatibility review to design the storage layout. Broad labels such as “acid” or “flammable” are not enough to make every storage decision.
Build a reliable inventory
Record each product’s name, concentration, quantity, container, hazards, storage conditions, incompatible materials, spill response and SDS revision. Reconcile the list against purchasing, receiving and waste records. Include aerosols, cleaning products, process samples, returned stock and damaged containers.
SDS storage recommendations are a starting point. The Canadian Centre for Occupational Health and Safety says storage arrangements should also account for the product hazards, amounts, containment and how the product is used. Apply the legal and standards requirements that govern the actual South African site.
Check compatibility and spill paths
Use product-specific information to check whether materials could react dangerously if containers fail or a fire affects a storage area. Review concentration, stabilizers, contamination and the conditions under which products are stored. Ask a competent person to resolve conflicts between SDS advice, fire-protection requirements and the facility design basis.
Then map how a spill could move through racks, floors, drains, doorways and bunds. Keep incompatible materials from sharing a containment area or drainage route where a credible release could mix them. A marked aisle is not a barrier if liquids can flow beneath it.
Design the layout for actual operations
The storage plan should show approved locations, compatible containment, ventilation needs, ignition controls, access routes and emergency equipment. Keep inventory limits and stacking arrangements visible to receiving and warehouse staff. Make sure damaged-goods isolation and waste staging do not become unreviewed storage zones.
Before accepting a new product, check its SDS and compatibility, select an approved bay, confirm containment and update the inventory. When a material, quantity, container or storage condition changes, review the decision through the site’s management-of-change process.
Include inspection and emergency response
Inspect labels, containers, racking, ventilation, containment and drains at a frequency set by the site’s risk and applicable requirements. Record defects and prevent damaged stock from being moved to an unsuitable location. Give staff a clear stop-work route when the product identity or assigned bay is uncertain.
Emergency teams need an accurate inventory, accessible SDSs, known isolation points and safe access routes. Test whether a spill from the highest-consequence storage area could block an exit or expose responders to incompatible materials.
Questions about chemical segregation
Can I store all products with the same hazard pictogram together?
No. A pictogram does not describe every incompatibility or spill consequence. Check the product-specific SDS and compatibility information before assigning a location.
Is distance enough to separate incompatible chemicals?
Not always. A spill can travel through a drain, doorway or shared bund. The layout must account for credible liquid paths and the protection needed for the actual products.
Does a compatibility chart replace an SDS review?
No. A general chart can help screen combinations, but site decisions should use current product information, quantities and storage conditions.